How Bubble Bag Manufacturers Can Cool the Production Workshop
In the hot summer, how can bubble bag manufacturers cool down? Wet curtain air coolers, environmentally friendly purification water evaporation air conditioners, heating and cooling air conditioning, industrial purification, ventilation ducts, heatstroke prevention and air purification in factory workshops.
In the hot summer, the cooling of the workshop has become a big problem. Some manufacturers of bubble bags use fans, ice cubes, air conditioners and atomizing cooling methods. These cooling methods have certain effects, but they also have certain shortcomings.
Fan cooling has a certain effect, but the temperature of the workshop itself is too high to cool down well. The cooling of the wind speed is based on the principle of increasing the volatility of the human epidermal moisture.
And because the workshop temperature is too high in summer, the wind blown by the fans is hot air, and the temperature that is blown to the human body is higher than the temperature of the human body. Even if the sweat can be more volatile, the temperature can be lowered, but the high temperature of the workshop causes the human body It is impossible to completely cool down, so the condition for the fan to cool down is that the air temperature is lower than the temperature of the human body, so that people can feel cool.
Bubble bag manufacturers use ice cubes to cool down. The principle is to use ice to liquefy and absorb heat. It is to use ice to liquefy to absorb the heat in the air. It is because the temperature of the air is lowered. However, because of the poor thermal conductivity of the air, the temperature range of the ice is relatively small If you want to use a large area, the cost is high.
Air-conditioning cooling is indeed an obvious effect, suitable for cooling in sealed environments such as workshops, but because the installation and use costs are relatively high, only high-value-added workshops can be suitable for use.
Atomization cooling is also an effective cooling method, but because the humidity is too large, it has a certain impact on machinery production and human body, so it is not suitable for workshop production. Belongs to the neutral cooling method.
A better method of cooling is to remove both heat and temperature. Only in this way can it adapt to the environment where the heat generated by the workshop is relatively large, and the air humidity cannot be too good. The more common method is the fan wet curtain ventilation cooling system